At Juniper, we understand that starting a self-injectable medication can feel a little intimidating, especially if it’s new to you. Our goal is to provide clear guidance so you can begin your treatment with confidence.
Each Wegovy pen provides one month of treatment and is used once a week for 4 weeks, with a new needle for each injection.
Let’s walk through the key steps together.
When to inject with my Wegovy MD (Multi-Dose) pen?
- Inject Wegovy once a week, on the same day, with or without food.
- Choose a quiet time when you won’t be rushed so you can follow each step of the injection process carefully.
Where to inject with my Wegovy MD pen?
- Injections should go into the subcutaneous (fatty) layer under the skin of your upper thigh, upper arm, or abdomen. Choose an injection site where there is more fatty tissue (for example : the front of your upper thigh rather than the back).
- Do not inject into an area where the skin is tender, bruised, red, or hard. You should also avoid injecting into areas with scars or stretch marks
-
Rotate injection sites weekly to avoid lumps, hardened tissue, or irritation.
How to inject with my Wegovy MD pen?
First-time injection can feel overwhelming, but don’t worry. We are here to guide and support you along the way.
🧼 Before Injection
- Wash your hands thoroughly.
- Inspect the pen before use for any damage and check the medication ; it should be colourless without any cloudiness.
- Clean your chosen injection site with an alcohol swab (provided).
💦 Once you are ready, please follow the steps below:
|
Step 1 - Attach the Needle Insert the back end of a new & unused needle straight into the rubber stopper and twist until it stops. Remove the outer cover and inner cap (green) by pulling them straight off. Remove the needle cover and needle cap by pulling them straight off. |
- Do not turn the dial unless a needle is attached, as this could damage the pen mechanism and make it unusable.
- Needle should be attached only when you use it.
🆕 FOR NEW / FIRST-USE PEN ONLY
| Turn the dial until the dashed line on the dose window aligns with the pointer, and check that liquid comes out from the needle tip. |
|
Step 2 - Set the Dose Turn the dial until your prescribed dose appears in the dose window. |
|
|
Step 3 - Inject the Dose Insert the needle into your skin by holding the pen flat and perpendicular to skin surface. Press the dose button and hold it against skin while pressing the button for at least 6 seconds. |
|
Maintain firm, steady pressure against skin (do not decrease) to maintain full skin contact without pressing too hard, as it may temporarily block the injection process.
🚯 After Injection:
- Attach the needle cover straight onto the needle, then remove the needle by unscrewing it together with the cover.
- To ensure safe handling, dispose of used needles and pens properly.
📺 Video Tutorial:
For visual guidance, here’s a helpful video showing how to use your Wegovy MD pen:
- Here (Japanese only)
You can also review the following detailed instructions for your reference:
🤔 FAQ
-
What if it seems that I didn’t receive any of the medication?DO NOT administer another dose. In most cases of pen malfunction, it’s unclear whether some of the medication was delivered, and it’s safest not to double your dose that day. Please contact our Medical Support Team before taking any further action.
-
What if I see some leakage after injection?
- A mild leakage does not necessarily mean that your dose will be any less effective.
- Leakage can have multiple causes and our Medical Support team will be able to assist you pending further assessment. Please reach out via here.
-
What if I see a drop of blood after removing the pen from my skin?
A drop of blood after removing the needle is normal in most cases.- Please lightly press the injection site with gauze or a cotton ball.
- Do not rub the injection site.
-
How do I reach out to Medical Support team?You can reach out to your Medical Support team via:
- Email at contact@myjuniper.jp
- LINE
- Enquiry Form